railway_modelling:kiha_23
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
railway_modelling:kiha_23 [2017/08/14 14:08] – dmmedia | railway_modelling:kiha_23 [2022/07/12 09:52] (current) – [Plans] dmmedia | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== KiHa 23 ====== | ====== KiHa 23 ====== | ||
+ | |||
+ | ===== Notes ===== | ||
+ | |||
+ | ==== 10.08.2017 ==== | ||
{{ : | {{ : | ||
- | == Changed KiHa 23 brought from Japan trip to HOm gauge from HO. Now looks much better and closer to prototype. == | + | Changed KiHa 23 brought from Japan trip to HOm gauge from HO. Now looks much better and closer to prototype. |
+ | |||
+ | For this photo I have used [[railway_modelling: | ||
+ | |||
+ | ==== 15.08.2017 ==== | ||
+ | |||
+ | I have cut plastic tubes on KiHa 23 wheelsets and adjusted axles, so KiHa 23 now has its original wheelsets changed to HOm gauge and [[railway_modelling: | ||
+ | |||
+ | ==== 20.08.2017 ==== | ||
+ | |||
+ | Researched micro coil solenoids and old mobile phone vibration motors use for automating couplers and doors. 0.04 mm enamelled wire is available on eBay in 100 g 9 km rolls. Coil resistance should be between 50 and 200 ohms. Magnetic power is proportional to turns count and current value. | ||
+ | |||
+ | ===== Plans ===== | ||
+ | |||
+ | * Add motor and replace or make one of the boggies motorized | ||
+ | * Change interior. Current interior has large cut hole for motor and steps for driving shafts. New motor will be placed under the floor, replacing current model of diesel engine. | ||
+ | * Add interior lightning | ||
+ | * Add DCC | ||
+ | * Add sounds | ||
+ | * Replace couplers with Kadee or make them DCC controlled | ||
+ | * Add exterior wiring | ||
+ | * Paint properly | ||
+ | * Weather paint | ||
+ | |||
+ | ===== Links: ===== | ||
+ | |||
+ | [[railway_modelling: | ||
- | This time I used [[railway_modelling: | + | Other KiHa series: |
- | Other plans include adding motor to the model and making doors open and close with DCC. | + | Other rolling stock: [[railway_modelling: |
- | Perhaps will change couplers to Kadee, but not sure about this. I might try to make existing couplers be DCC controllable. | + | |
- | I should also add electric and pneumatic wiring to the car. | + |
railway_modelling/kiha_23.1502719695.txt.gz · Last modified: 2017/08/14 14:08 by dmmedia